HomeAudi S3 P Plate Legal Nsw

Audi S3 P Plate Legal Nsw

Restrictions on high-performance vehicles apply to Queenslander P1 and P2 licence holders under the age of 25 or over the age of 25 if they are returning from disqualification to a P1 or P2 test licence and were under 25 years of age at the time of the offence. These restrictions apply to the rest of the period of indicator P, regardless of age. In New South Wales, you must first purchase an apprenticeship licence and then upgrade to your P1 licence (your red P licence plate) and your P2 licence (your green P licence plate). Once you have completed the two provisional phases, you can apply for a full license. The recent change in vehicle restrictions for P licence plate holders in Queensland, New South Wales, Victoria and South Australia allows these drivers to drive a vehicle with a power-to-weight ratio of less than 130 kW per tonne. The list is not exhaustive; For example, if you are a P-Plater or a relative or friend of a P-Plater who owns a classic Holden, the 1978 VB Holden Commodore 4.2 V8 is approved for a P-Plater. However, if you want to drive very similar vehicles from 1979 in the VB series to VH Commodore, they are not on the list. The NSW rule of 130 kW per tonne applies to almost all vehicles and therefore gives P-Platers the option to drive forced induction vehicles or vehicles with eight or more cylinders, provided they comply with the power-to-weight ratio restriction. Before August 2014, almost all of these cars were banned from P license plates. The above exceptions that can be powered by a P-Plater are: Suzuki Cappuccino 2D Cabriolet Turbo 3 657â698cc (1992-1997); Daihatsu Copen L880 2D Cabriolet Turbo 4 659cc (2003 or later); Smart Fortwo Coupe 2D Turbo 3,698cc (2000 or more); Smart Fortwo Cabriolet Turbo 3 2D 698cc (2000 or more); Smart Roadster Turbo 3 2D 698cc (2000 or higher); Toyota LandCruiser. For vehicles from 1 January 2010, P-Plate drivers in South Australia will be able to drive almost anything with a power-to-weight ratio of less than 130 kW per tonne. In addition, Victoria allows P-Platers to drive certain Ford Ecoboost, Holden Turbo and Nissan turbo vehicles (without applying for an exemption), provided they have a performance identifier on the build date plate (vehicles manufactured before January 1, 2010) indicating that they have less than 130 kW of power per tonne. It`s a hard truth, but young people have a different set of rules than the rest of us.

While this may seem unfair to the younger generation, some of these rules exist for a very good reason. P-plate restrictions and special rules in New South Wales are an example of this type of rule. There is another large group of cars that meet the 130 kW /ton rule, but cannot be driven by a P-Plater. The RMS list of novice drivers – Restrictions on high-performance vehicles includes more than 600 vehicles that authorities deem too risky for young drivers. Victorian P-Platers may also drive vehicles under the club`s registration system (i.e., under the Program for Vehicles 25 Years and Older), unless the vehicle exhibits engine performance changes other than those made by the vehicle manufacturer. In South Australia, restrictions on high-performance vehicles are mandatory for P-Platers under the age of 25 who obtained their P1 driving licence on 4 September 2010 or who were disqualified and returned to driving on or after 4 September 2010 with a P1 driving licence. The same rules apply to Victoria, except that there is no general exemption for diesel vehicles and Victoria also puts certain high-performance naturally aspirated six-cylinder engines on the prohibited list. Some compressors or turbocycles can be driven by a P-Plater. Here you will find the database of prohibited vehicles in Victoria and more general information on restrictions on P-Plate vehicles can be found here.

The list of approved vehicles can be found here and more details on restrictions on Queensland P-Plate vehicles can be found here. The landscape has changed for P-Plater, with some states limiting which cars can be driven on a power-by-weight calculation. If it is a question of combating the over-representation of young drivers in road accidents, the rules themselves are far from simple. There are exceptions in South Australia, such as Victoria, where turbocharged or supercharged vehicles that have low power and are designed for efficiency relative to power are allowed to drive for P-Platers. More information can be found here. Restrictions on high-performance vehicles in South Australia do not apply to P-Platers who are 25 years of age or older or who obtained their P1 or P2 licence before 4 September 2010. The above states also offer exemptions for P-Platers who drive prohibited vehicles according to work requirements or if they have no choice but to drive such a car. In most cases, an application must be made to the appropriate state road authority to obtain a permit in such circumstances. For Queensland, this means that a P-Plater cannot drive: vehicles with eight or more cylinders; all turbocharged or supercharged petrol vehicles (forced-wheel drive diesels are allowed); all vehicles with an engine power exceeding 210 kW; and all gyroscopes with a displacement greater than 1146 cm³. Queensland, New South Wales, Victoria and South Australia have restrictions on P-Plate vehicles, while P-Platers in the ACT, the Northern Territory, Western Australia and Tasmania are not limited by power restrictions in weight.

P license plate holders in these states and territories can drive anything that an unrestricted driver in the driver`s license class can drive with less than 4.5 tons of GVM. But additional rules mean additional confusion! This article describes the limitations of the P disk in NSW and the rules that P disks must follow beyond the general NSW traffic rules. Red and green P-Platers can only get 4 demerit points before getting their licence suspended in New South Wales, far less than the 12 points required to suspend a full licence. This means that some crimes result in an immediate suspension of licences. In all of the above states, P-Platers are not allowed to drive a vehicle that has been modified except by the manufacturer. If you`re looking for a great way to get around as a P-Plater that doesn`t include the hassle and cost of owning a private car, consider GoGet Carsharing. With a wide range of vehicles across the country (over 2,600 in total), you can use the car you need for any trip. And it`s much cheaper than renting a car for short, regular trips.

Some vehicles may not appear in the search or may be listed as «for verification». This is because they can be older, newly released or niche vehicles. If you have to drive a prohibited vehicle, you can apply for an exemption. Exceptions will only be granted in exceptional circumstances. Indeed, prohibited vehicles pose a high risk to drivers on their Ps. GoGet`s editorial team is a mix of former journalists, novelists and experts in future mobility and smart city design. Learn about the rules for test prohibited vehicles, prohibited vehicles, exceptions, and answers to frequently asked questions. High-performance vehicles have higher acceleration and performance than other vehicles. The more power a vehicle`s engine has relative to its weight, the more acceleration it can offer. If you`re on your red or green P, there are certain vehicles you can`t drive.

Find out what the rules are. If you`re not sure about a vehicle`s specifications, you can: South Australia also has similar restrictions to Queensland and Victoria with the date of manufacture on January 1, 2010. For vehicles manufactured before January 1, 2010, vehicles with eight cylinders or more, turbocharged or supercharged vehicles (with the exception of diesel vehicles with less than eight cylinders) or a vehicle designated as a high-performance vehicle are prohibited. More information can be found here. The 130 kW per tonne rule means that the vehicle must have no more than 130 kW of peak power per tonne of sound (unladen weight). This rule replaces the general prohibition in all the above conditions of all forced induction vehicles and vehicles with eight or more cylinders. As is often the case with such rules, they can change, and you need to clarify what you are allowed to drive on your state`s highway authority website. If you are looking for one of these vehicles, please contact us by phone at 13 22 13 or by email. To find out which vehicles you can and cannot drive, use the P1 and P2 vehicle search. Young and inexperienced drivers are statistically much more likely to be involved in an accident than older, experienced drivers. This is especially true in the first few months of solo driving.

As a result, the NSW Roads and Maritime Service has established strict rules on what learners and makeshift drivers can and cannot do on the road.